Recent content by Rover1312

Received the package thanks! Feedback added.

My tip is fine , i clean it and its a decent iron ive been using it for a few years now sequire 65w si012 iron , the issue is heat wont goto the pads fast enough ill try a different tip

Heres the pic , i stand corrected they used spot welds between the batteries but the main power leads are still soldered. And also balance plug wires are soldered ontop of the welds? Idk wouldnt it be better to just solder in the first place if they were gonna solder ontop of the welds

Hi , so all the tabs are soldered to each other , not a single spot welder was used , im assuming thats because these are high discharge batteries that can do 100A discharges and using spot welds would cause more heat while discharging.

the other tab of the battery is soldered to a wire , the factory didnt use a spot welder. Ive tried scratching and everything i just cant get a good enough heat transfer. Im running my iron at 450C. This is a high discharge lipo so the tabs dont heat up that easily.

activated 3months career thanks!

Hey fellow DIY enthusiasts, I could use some advice on soldering LiPo battery tabs. I have a 4S CHNL 1500mAh 100C LiPo that I used for my FPV drones. Unfortunately, my charger died mid-process, and it ended up killing 2 of the cells. To salvage it, I converted the battery to a 2S setup...

Do you have any 6month plans?

Paid for 1x green&orange.

Yea it used to turn off then cooldown and restart.

Idk about the stavis 2 models but i have 70mai A500S on both my cars. They have performed really well during night time, whenever i wanted to make insurance claims never had an issue with quality of footage. Only downside i had with the cameras was they would overheat in summers when outside...

Last year i replaced my hp x360 440 g1 battery from a techie: https://techiestore.in/ , the battery is really good i get good backup aswell. The only issue i have with it is that i get a White screen stating that battery is not original everytime i boot the laptop up and im required to press...

Ive been using the Bridge app for a month now to connect my Wear OS watch with my iPhone, and I’m seriously impressed! If you're an iPhone user with a Wear OS smartwatch, you've likely run into some frustrating limitations. Officially, Apple and Google haven’t made it easy to bridge the gap...

when getting an AC check for something like a convertible AC that can run at 40% load, the power consumption are really really low , i have a 5star panasonic 1Ton AC and running it for 10hrs a day consumes around 4kWh. model: CS/CU-NU12ZK5W 2024.

have you checked mercusys love their routers, im using mr90x connected via the 2.5gbps port to a tplink xc220 gpon router.