Cloning Security Dongle

N

navino87

Disciple
Hello friends.. I recently have purchased a Laser machine.. This machine comes with LASERCUT software and to open this software, it requires a security dongle to be inserted in the USB port.. The problem is that I would be using 2 computers for designing the work with lasercut.. Every time, I don't wanna carry the dongle with me and even if i do this, it might damage the dongle which would be a real pain in arse.. So, It would be great if someone could help me with cloning the dongle or emulating the software to work without dongle.. I know its kind of illegal. But Iam looking for alternatives to use the software without dongle..

TY
 
I believe software must be identifying the serial no embedded into the dongle ........ FTDI has a tool to reprogram their USB chip FT xxx for this purpose. I am not sure about chip used in your dongle .......... Any idea how does it shows up in hardware list ...... Vid n pid of device.....
 
attrish said:
I believe software must be identifying the serial no embedded into the dongle ........ FTDI has a tool to reprogram their USB chip FT xxx for this purpose. I am not sure about chip used in your dongle .......... Any idea how does it shows up in hardware list ...... Vid n pid of device.....
Click to expand...


It shows as a smart card reader device with name - Senselock Elite IV v2.x.

VID - 0471
PID - 485d

TY
 
Back
Top