D-link modem problem! need solution

Status
Not open for further replies.
gREen

gREen

Im Special, gREen.
Herald
hello guys got a second hand d-link dsl-2640T modem+router from Te.

Im using bsnl 750plus and trying to connect with it but still no luck.

tried going to 192.168.1.1 and configued the username and password and all...

still cant get connected...

need solution as it was lying idel for a week...
 
@thatashok, already tried these tutorial, still no luck.

should i try with motive(bsnl setup for know modem, where this one is not included) will flash the dlinks firmware..
 
did you try this guide also. This seems to be clear.

flash d-link firmware ? so what firmware was that running

Actually this should do

[font=arial,helvetica,sans-serif]1. connect modem through LAN port

2. power on modem

3. open browser ; type http://192.168.1.1/ and enter admin for user name and admin for password

4. modem's web configuration interface will come up . click on WAN

5. change vci value to 35 (pvc->0 and vpi -> 0)

6. select wansetting as pppoe/pppoa

7. enter your dataone user name and its password for PPPoE/PPPoA

8. finally go to Tools->System. click on “Save and Reboot†.[/font]
 
^mate i tried, still it doesnt work..

can you please explain whats bridge mode is.
 
In bridge mode the modem works as transparent Ethernet bridge and therefore you need to run the PPPoE client software ( for login authentication) on your PC.

you might be familiar with the dialer. Itlooks like this

uRsC4.jpg


In PPPOE mode the modem dials itself and gives you a internal/private ip. No dialing on PC required

The both setups are given here
 
Status
Not open for further replies.
Top Bottom