Well, i got my new build iup and running, and i will be adding a WC kit with a lot of bling soon So this means loads of LED fans and Cathodes etc etc. Now i wanted to control the intensity of the LED's (of the Fans only at the moment,to start with) and i was thinking - why not use a fan controller knob setup to act as a dimmer switch.
Here is my idea -
Disconnect all LED's on all the fans, pass them all through a single channel and into a single 3-pin fan connector which will then connect to the fan controller. Now will this setup work ? Also what else do i need to put in the circuit, like resistors etc ? Also, any tips on designing the circuit ? Trying to make it as mess free as possible.
Here is my idea -
Disconnect all LED's on all the fans, pass them all through a single channel and into a single 3-pin fan connector which will then connect to the fan controller. Now will this setup work ? Also what else do i need to put in the circuit, like resistors etc ? Also, any tips on designing the circuit ? Trying to make it as mess free as possible.