PC Peripherals Dual Display using CRT only ...

[JPushkarH]

I have GigaByte 880GM-UD2H ..... I am using it on Old CTR monitor LG 700E

Recently I got one old CRT monitor Samsung Smtron . . .

my bord supports

Dual Display Configurations:
This motherboard provides three ports for video output: DVI-D, HDMI and D-Sub.
The table below shows the supported dual display configurations.

Combination...........Supported or Not
DVI-D + D-Sub...........Yes
DVI-D + HDMI.............No
HDMI + D-Sub............Yes

planning to have dual (not duplicate) display . . . so I recently bought DVI-I to VGA converter but no luck I have DVI-D Port on m-board .... which does not support analog output ...

Is there any way to have dual Display with 2 CRT on my Board ... ?

any tweak for DVI-D / HDMI (Digital) to CRT VGA (Analog) ....?
or I need to have one LCD/LED (Digital) monitor .....

 

[JPushkarH]

Bump

Any solution ... ?

 

[JPushkarH]

..............bump................

 

[6pack]

Dont bump the topic. There are no answers cause no one knows the solution.

Let us get this fact right first. Are you trying to get dual display with two crt monitors?

 

[vivek.krishnan]

Try using a DVI-D to VGA adapter, see whether you are able to get a signal. If your mobo can send analog signals over DVI-D, it may work.

Else, you are flat out of luck mate.

--- Updated Post - Automerged ---

like this Newegg.com - Rosewill RA-VGA-DVI-D 25pin (24+1) DVI-D male to 15pin VGA female Adapter

or try your luck with a HDMI to VGA adapter.

 

[allrounder799]

For turning DVI-D(Digital Input) to VGA(Analog Input) you will need a specific converter device and not just an adapter or cable because CRT cannot accept Digital signal.

From your supported configuration, you can use a HDMI TO CRT conversion device and use as HDMI+D SUB

 

[JPushkarH]

Any any solution for dual display ... on GigaByte 880GM-UD2H

--- Updated Post - Automerged ---

got this HDFury $ 250 expensive