Storage Solutions Got a new Drive, But how to tell its new?

[ssr]

I recently got a new OCZ agility 3 from Ebay.
And tested with SSD life, But could not able to find.

The screenshot from the SSDLife,

SMART READ DATA (from OCZ toolbox)

Model Number : OCZ-AGILITY3
Serial Number : OCZ-xxxxxxxxxxxxxxxxx
WWN : xxxxxxxxxxxxxxxxxxx

Revision: 10
Attributes List
1: SSD Raw Read Error Rate Normalized Rate: 120 total ECC and RAISE errors
5: SSD Retired Block Count Reserve blocks remaining: 100%
9: SSD Power-On Hours Total hours power on: 2
12: SSD Power Cycle Count Count of power on/off cycles: 1
171: SSD Program Fail Count Total number of Flash program operation failures: 0
172: SSD Erase Fail Count Total number of Flash erase operation failures: 0
174: SSD Unexpected power loss count Total number of unexpected power loss: 5
177: SSD Wear Range Delta Delta between most-worn and least-worn Flash blocks: 0
181: SSD Program Fail Count Total number of Flash program operation failures: 0
182: SSD Erase Fail Count Total number of Flash erase operation failures: 0
187: SSD Reported Uncorrectable Errors Uncorrectable RAISE errors reported to the host for all data access: 0
194: SSD Temperature Monitoring Current: 128 High: 129 Low: 127
195: SSD ECC On-the-fly Count Normalized Rate: 100
196: SSD Reallocation Event Count Total number of reallocated Flash blocks: 0
201: SSD Uncorrectable Soft Read Error Rate Normalized Rate: 100
204: SSD Soft ECC Correction Rate (RAISE) Normalized Rate: 100
230: SSD Life Curve Status Current state of drive operation based upon the Life Curve: 100
231: SSD Life Left Approximate SSD life Remaining: 100%
241: SSD Lifetime writes from host Number of bytes written to SSD: 20 GB
242: SSD Lifetime reads from host Number of bytes read from SSD: 19 GB

please tell me whether its new or used?
Thanks in advance.

 

[Xanthor]

Given that your screen shot shows that its been powered on a grand total of 6 times; I think you can be relatively certain that its new.

 

[CA50]

^ I guess that not the accurate one.

@OP, if you check the SMART panel, there is an attribute - Power -on Hours Count whose value is 64, it means that your drive was running for 64 hours (was ON for 64 hours)

Now its upto you to decide if it is used or New.

 

[ssr]

well my 2 year old heavily used drives has Power on hours count 65-75

 

[CA50]

^ then you can try Hard Disk Santinel, it will show your drive usage