Hello,
The following has worked for me for auto saving the Volume and other settings for my Z5500. I am not sure how good it works for you all.. just give a try.
All you need is a headphone/earphone.
1. Power on the Z5500
2. Select the required source ( If necessary). Ex:-Coax/optical is default/analogue
3. Now raise the volume control to your desired values. In fact you can raise all the 6 channels to required levels.
4. Now insert the headphone jack to listen through it through the control center of Z5500. ( If there is a headphone button on remote, press it so that the LED also goes off in control center).
5. Now remove the headphone.
You are all done.. In case if you loose the settings at any point of time, just repeat the above process.
I have been using the same settings that were set from above guide from about a month. (Coax, Volume at 25% for all channels)
Hope this helps you. Happy listening.
The following has worked for me for auto saving the Volume and other settings for my Z5500. I am not sure how good it works for you all.. just give a try.
All you need is a headphone/earphone.
1. Power on the Z5500
2. Select the required source ( If necessary). Ex:-Coax/optical is default/analogue
3. Now raise the volume control to your desired values. In fact you can raise all the 6 channels to required levels.
4. Now insert the headphone jack to listen through it through the control center of Z5500. ( If there is a headphone button on remote, press it so that the LED also goes off in control center).
5. Now remove the headphone.
You are all done.. In case if you loose the settings at any point of time, just repeat the above process.
I have been using the same settings that were set from above guide from about a month. (Coax, Volume at 25% for all channels)
Hope this helps you. Happy listening.
