CPU/Mobo In deep trouble...help!!!

[harshit143]

Today i booted my PC after 4-5 days. As soon as i turned it on, the display didnt appear. I restarted the PC, and then i got this blackscreen message shown in attached picture. Now, i have Asus 4870 and Msi motherboard from past 2 years. Another thing i noticed was, the GPU's power lights(4 red lights near the 6 pin connector), from those 4, 3 are blinking after every 3-4 seconds. Second thing was, the 5 active phase switching lights of motherboard, out of which atleast 4 used to blink, are only 2 blinking. This attached message is not appearing everytime. I followed the instructions in the message but nothing is happening.

whats the problem?? is my motherboard faulty, Ram or GPU?? I have onborard graphics also but when i am connecting the display from them, the display is not coming.

 

[Mr.J]

I have onborard graphics also but when i am connecting the display from them, the display is not coming.

View attachment 14067

When you connected display to onboard graphics, did you removed the graphics card first?
Are able to get into BIOS?
If yes, select option to load failsafe defaults and boot again.

 

[StillWaters]

Today i booted my PC after 4-5 days. As soon as i turned it on, the display didnt appear. I restarted the PC, and then i got this blackscreen message shown in attached picture. Now, i have Asus 4870 and Msi motherboard from past 2 years. Another thing i noticed was, the GPU's power lights(4 red lights near the 6 pin connector), from those 4, 3 are blinking after every 3-4 seconds. Second thing was, the 5 active phase switching lights of motherboard, out of which atleast 4 used to blink, are only 2 blinking. This attached message is not appearing everytime. I followed the instructions in the message but nothing is happening.

whats the problem?? is my motherboard faulty, Ram or GPU?? I have onborard graphics also but when i am connecting the display from them, the display is not coming.

View attachment 14067

@harshit143: If you can go into Bios settings. Do as Mr.J suggested for Failsafe defaults. In order to use the onboard graphics, you need to make sure that Bios settings for initating on board graphics first.

 

[booo]

usually this happens when you reset the pc few times during the bios POST. just reset the bios to default settings and start over. I dont think its a big problemo.