Hi Folks,
I recently brought Aritel vFiber and got a static IP complimentary with my plan.
I am having issue in configuring the ip, i have configured wan0 with that static ip and it is being reflected when i check with my laptop with the lan cable attached.
I am using a DELL R730xd here and installing cPanel in it, the installation goes flawlessly, the only issue is that i suppose inbound traffic is restricted on it, i have tried port mapping for port 2087 (this port contains WHM in case of cPanel iinstallation) but i get connection refused message on it, all ports that i try give the same message.
I saw people using bridge mode in the router in some forum posts, is using a bridge mode the only way, if yes, do i need a lan switch with it or an additional router. I used bridge mode without any additional hardware but the issue is that, in that case, only 1 port is activated in bridge mode and that is not feasible for me since i need 2 ports, 1 for the server and one for its iDRAC
If i take 2 ips and turn the router back to bridge mode, that is fine ?
In bridge mode, is outgoing and incoming traffic allowed by default and ports like 80, 443 etc are open ? if not, what is the way to do it ?
It is my first encounter with static ip provisioning, so i have almost no knowledge.
Help in getting it done will be much appreciated.
I recently brought Aritel vFiber and got a static IP complimentary with my plan.
I am having issue in configuring the ip, i have configured wan0 with that static ip and it is being reflected when i check with my laptop with the lan cable attached.
I am using a DELL R730xd here and installing cPanel in it, the installation goes flawlessly, the only issue is that i suppose inbound traffic is restricted on it, i have tried port mapping for port 2087 (this port contains WHM in case of cPanel iinstallation) but i get connection refused message on it, all ports that i try give the same message.
I saw people using bridge mode in the router in some forum posts, is using a bridge mode the only way, if yes, do i need a lan switch with it or an additional router. I used bridge mode without any additional hardware but the issue is that, in that case, only 1 port is activated in bridge mode and that is not feasible for me since i need 2 ports, 1 for the server and one for its iDRAC
If i take 2 ips and turn the router back to bridge mode, that is fine ?
In bridge mode, is outgoing and incoming traffic allowed by default and ports like 80, 443 etc are open ? if not, what is the way to do it ?
It is my first encounter with static ip provisioning, so i have almost no knowledge.
Help in getting it done will be much appreciated.