Need Help with DD-WRT Buffalo HP G54

I

idoc2020

Apprentice
I picked up a used wireless router that I want to use as an access point. I tried to set it up but it has been flashed with the DD-WRT firmware upgrade. The problem is I have no idea how to access the GUI interface to change or administer the settings. I tried 192.168.11.1 but no luck? Does anyone have any suggestions? Thanks
 
The administration page of dd-wrt will be accessible at 192.168.1.1

Buffalo's Default Subnet is 192.168.11.x but after flashing to dd-wrt it changes the subnet to 192.168.1.x
 
If DD-WRT doesn't work with that ip, then someone has changed it. You will need to hard-reset the firmware by pushing in the reset button on the back, then re-boot the router again, and then trying the ip address as above.
 
Back
Top