M malchom Beginner Aug 9, 2012 #1 This is a friend's PC and it had been off for about a year.... Mobo: MCP61SM-AM Rev:1.0A Problem: No display on the monitor. No mobo speaker sound...(NO single beep that says that its working fine) Pls help... Thanx...
This is a friend's PC and it had been off for about a year.... Mobo: MCP61SM-AM Rev:1.0A Problem: No display on the monitor. No mobo speaker sound...(NO single beep that says that its working fine) Pls help... Thanx...
S Sei Galvanizer Aug 9, 2012 #2 Change CMOS battery. That will most probably be the reason since the PC has not been used for over a year.
Change CMOS battery. That will most probably be the reason since the PC has not been used for over a year.
manucitc Herald Aug 9, 2012 #3 Re attach ram and remove cmos battery and attach.most probably problem will be solve with this
M malchom Beginner Aug 10, 2012 #4 Tried reinserting the RAM's, and even cleaned it...did not help.... tried with a another working RAM, did not work.... Bios battery also does not help.... any other suggestions....???
Tried reinserting the RAM's, and even cleaned it...did not help.... tried with a another working RAM, did not work.... Bios battery also does not help.... any other suggestions....???
Gannu Unbanned Juggernaut Aug 10, 2012 #5 Must be a cheap (enclosure bundled?) power supply causing the issue? Try swapping the power supply and check.
Must be a cheap (enclosure bundled?) power supply causing the issue? Try swapping the power supply and check.
M malchom Beginner Aug 11, 2012 #6 Gannu said: Must be a cheap (enclosure bundled?) power supply causing the issue? Try swapping the power supply and check. Click to expand... tried with a another smps, same issue!!!
Gannu said: Must be a cheap (enclosure bundled?) power supply causing the issue? Try swapping the power supply and check. Click to expand... tried with a another smps, same issue!!!
nish_pinto Voyager.Fpv Forerunner Aug 12, 2012 #8 Apply some thumb pressure on the northbridge and try starting it again.
M malchom Beginner Aug 13, 2012 #9 nish_pinto said: Apply some thumb pressure on the northbridge and try starting it again. Click to expand... Shall try this!!
nish_pinto said: Apply some thumb pressure on the northbridge and try starting it again. Click to expand... Shall try this!!
M malchom Beginner Aug 22, 2012 #10 nish_pinto said: Apply some thumb pressure on the northbridge and try starting it again. Click to expand... does not work!!
nish_pinto said: Apply some thumb pressure on the northbridge and try starting it again. Click to expand... does not work!!
nish_pinto Voyager.Fpv Forerunner Aug 22, 2012 #11 Then try reflowing the northbridge using a heat gun.
