sreeram180
Discoverer
hi guys
A GUIDE for lighting urs PC
requirements:
if want to connect more than one LED strip to single 4 pin molex connector .by using terminal block u can manage the multiple LED stripes .
actually i didn't try terminal block because its not available in my place.so its available in ebay
1 x 12 Position Terminal Block Strip 10A / 12V | eBay
This image has been resized. Click this bar to view the full image. The original image is sized 752x410.
i used 18 led in each strip .its working fine .check the pics
total build cost is 100/- for strip of 36 LED(2x18 led)
This image has been resized. Click this bar to view the full image. The original image is sized 1024x768.
This image has been resized. Click this bar to view the full image. The original image is sized 768x1024.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x768.
if any wrong with LED strips .i am not responsible for that.
take safety measure to modding the lights
Thanking you
A GUIDE for lighting urs PC
requirements:
- 12v DC led lighting strip( length and color depending on you)
- 4 pin molex connectors
- some wires
- soldering
- soldering two wire to LED strip .In this case i used RED wire as positive terminal and BLACK as negative terminal.
- connected positive terminal to YELLOW(+12v) color wire in 4 pin MOLE X
- connected NEGATIVE terminal to BLACK (gnd) color wire in 4 pin molex
- connect the molex to PSU
if want to connect more than one LED strip to single 4 pin molex connector .by using terminal block u can manage the multiple LED stripes .
actually i didn't try terminal block because its not available in my place.so its available in ebay
1 x 12 Position Terminal Block Strip 10A / 12V | eBay
i used 18 led in each strip .its working fine .check the pics
total build cost is 100/- for strip of 36 LED(2x18 led)
if any wrong with LED strips .i am not responsible for that.
take safety measure to modding the lights
Thanking you
