Hi i bought a new WD 1TB Internal HDD for my PC about 9 odd months ago as my existing 500GB Sansung wasnt sufficient.
All was good until this morning when My Computer only showed the old 500GB HDD & not the 2 partitions of my new 1TB HDD.
The Device Manager still showes it but thats it
I removed the SATA wire going from the HDD to the Motherboard, cleaned & reattached it - nothing.
Removed the wire again & put it in another SATA slot on the MB & restarted the pc & it detected the hdd & all was good.
Switched-on the PC again now & its again not detecting the new HDD, i tried doing the above again a few times but no luck.
All my important stuff is in there & any help on tiding over this problem will be most appreciated.
All was good until this morning when My Computer only showed the old 500GB HDD & not the 2 partitions of my new 1TB HDD.
The Device Manager still showes it but thats it

I removed the SATA wire going from the HDD to the Motherboard, cleaned & reattached it - nothing.
Removed the wire again & put it in another SATA slot on the MB & restarted the pc & it detected the hdd & all was good.
Switched-on the PC again now & its again not detecting the new HDD, i tried doing the above again a few times but no luck.
All my important stuff is in there & any help on tiding over this problem will be most appreciated.