It worked. Batch file worked with gateway 10.116.119.156
But another problem is there.
When I switch off the Tikona CPE and switch on the again, It take 5-7 minutes to detect the gateway as 10.116.119.156.
Sometimes I need to enable/diable/enable lan adaptor many times.
Sometimes I need to again switch off/on the CPE power.
It , sometimes , tool 10-20 minutes to get proper gateway after due error & trial.
What is this phenomenon?
Are u experiencing such events i.e. hit and trial reconnection issues.?
I attached the lan adaptor status before detection of CPE by laptop i.e.
After 3-4 minutes of switching off/on CPE power.
That is an issue with Tikona.In fact your ping speed of 1.7 s is very bad.
I faced this issue with Tikona one month back when the CPE took 15-20 mins to connect to the AP only after which the ip was assigned to the router.
I had to raise this issue to Tikona umpteen number of times before which my speed was fixed. I get averages of 40-50ms (10.23.64.1) now.
There is no workaround for that issue from our side.