Buffalo WHR-G54S not working

[apextwin146]

So i come back from Work i notice that there is no wireless signal in my house. I check my Router and see that the 'G' Sign is not glowing thereby indicating that its not transmitting any wireless Signal. I unplugged it and then plugged it back again to my suprise All the Lan jack LEDS lit up even though nothng was connected. Not everytime i unplug the power cord and reconnect a Different set of LEDS glow but there is no wireless signal. I have tried a Init thing but its futile.

The Airtel Beetex modem to which this router was connected is working fine.
WHR-54s was loaded with Tomato Firmware and it doesnt not have any warranty.

Can someone guide me on a suitable course of action?

--- Updated Post - Automerged ---

Anyone?
10 char

 

[dyna]

can you connect using wired connection and access the router page ? probably you can get some info from the logs.

or just restore to defaults or reflash the firmware...

 

[akitosforever]

tried conventional hard Power resetting??...( keeping the power button prssed for 5 seconds until flea power is drained)

 

[apextwin146]

Tried Conventional Hard Power Reset bu it dsnt work.
The problem is how do i access the Router Page after i connect the Router?IPs dont work since there is no proper DNS in place. I dont knw how to work with tftpd commands too

 

[Freaky]

Check this : Recover from a bad flash - DD-WRT Wiki

 

[apextwin146]

i have checked that out. I tried a Hard Reset,30/30/30 Reset but nothing. Its like its not booting properly itself as everytime i plug it on different LEDS glow in the front and back ...

 

[asingh]

can you connect using wired connection and access the router page ? probably you can get some info from the logs.

or just restore to defaults or reflash the firmware...

Are you not able to connect the router to your machine using a RJ45 cable..? Then it should be easy to access the router configuration pages..? 192.168.....