my rig is as below:
E7200
GA-G31M-S2L
Transcend 2x2GB 800MHz
WD6400AAKS
Samsung SH-S223F
VX450
Now I replaced G31M with EG31M and everything is working fine.
Problem is with the rig I moved G31M in. It's spec are:
E2160
GA-G31M-S2L
Transcend 1x2GB 800MHz
WD6400AACS
Samsung SH-S223F
Zebronics Generic 450W PSU
Everything is new except the G31M which is borrowed from the 1st rig.
when I press the power button ON, all fans are working including the CPU fan,
but there is no display, also the HDD led is not glowing.
When I remove the DVI-sub cable from the mobo, monitor (E178WFP) displays auto check, red, green, blue.
when I connect it to mobo monitor goes to power saver mode and displays nothing.
Now what might be the problem? :huh:
IMO it's not the mobo since it was working fine in the 1st rig.
E7200
GA-G31M-S2L
Transcend 2x2GB 800MHz
WD6400AAKS
Samsung SH-S223F
VX450
Now I replaced G31M with EG31M and everything is working fine.
Problem is with the rig I moved G31M in. It's spec are:
E2160
GA-G31M-S2L
Transcend 1x2GB 800MHz
WD6400AACS
Samsung SH-S223F
Zebronics Generic 450W PSU
Everything is new except the G31M which is borrowed from the 1st rig.
when I press the power button ON, all fans are working including the CPU fan,
but there is no display, also the HDD led is not glowing.
When I remove the DVI-sub cable from the mobo, monitor (E178WFP) displays auto check, red, green, blue.
when I connect it to mobo monitor goes to power saver mode and displays nothing.
Now what might be the problem? :huh:
IMO it's not the mobo since it was working fine in the 1st rig.