PC Peripherals PC gone dead

Status
Not open for further replies.
rishabh.asthana

rishabh.asthana

Discoverer
hi guys...just started my PC and after 10 mins it stopped working...now the motherboard Abit IP35 Pro is showing code 8.2 which stands for "Enable ATX power supply" also the PC keeps on starting and shutting down i.e all fan leds its up and the CPU fan moves a bit then it stops and after some seconds it lights up again and stops...so whats the problem guys is my power supply gone (CM 600W) or is it my motherboard ?:S
 
Re: HELP PC gone dead

Highly probable that the PSU is finished. When you power the system, check if the PSU fan is spinning. Try another PSU.
 
Re: HELP PC gone dead

rishabh.asthana said:
PC keeps on starting and shutting down i.e all fan leds its up and the CPU fan moves a bit then it stops and after some seconds it lights up again and stops
Click to expand...
Its a Problem with the P35 boards,my Ip35P board keeps on starting and shutting down if it does not boot properly :rofl: and most probably your PSU is finished...:P
 
Re: HELP PC gone dead

My Abit IP35 Pro also died, same error code, so I RMAed my Corsair HX620 w/o checking :ashamed:, I got shiny new PSU without any hassle (in 2 days, no bill asked), mobo still does not boot up.

I am pretty sure your mobo is dead.
 
Is this something specific to ABIT P35s. What are the ages of all your motherboards...?
 
m/b is about 2 years old...problem is that i dont have spare smps with me to check if the m/b is dead or smps is gone :( i was anyway going to change my smps...also i dont think that the m/b is dead cause the fans which are directly connected to the smps are also showing the same behavior, they are switching off and switching on...
 
Come the heat, and CM Extreme series are popping off. I think this is the 4-5 case I am reading within this week. TE+TDF.

Bad PSU.
 
Just try disconnecting and connecting peripherals one by one to narrow down the problem
Had the same problem to which the problem found was a shorted 80 gig hard disk.
 
well changed my power supply (bought a new Everest 500W modular PSU for 5k :( ) now the pc boots up but no display :( any suggestions i have reinstalled the gfx but still no disp :(
 
the abit ip35's have a dual boot problem ......

even i used to face this on my abit ip35e.....a bios update should help
 
Status
Not open for further replies.
Top Bottom