PC Peripherals UPS recommendation 1000 VA

calvin1719

calvin1719

Mostly harmless.
Skilled
I didn't want to hijack lockhrt999's thread anymore, so starting one here for recos.

I need a 1000 VA UPS for short term backup, just while my society's genset kicks in. The genset takes 5-10 seconds each time the power goes out/comes back, and it's irritating to have my PC shut down. Not to mention possible damage to components.

I've shortlisted (based on availability) these:

APC BX1100-IN for 6600 https://eshop.se.com/in/bx1100c-in.html
Microtek UPS Legend 1000 for 5500 or 5800, depending on whether I get it from Microtek's site or Amazon https://www.amazon.in/Microtek-UPS-Legend-1000VA/dp/B08349YMCP or https://www.microtekdirect.com/ups-legend-1000-70.html

I'm leaning towards APC because it has 5 outputs vs 3 in the Microtek, but I'm not sure if it's worth 1100.

For context, my CPU+GPU peak load is ~300W, and I have a ~50W RMS speaker system. So potentially at full load it would be in the ~450W range, which is why I don't want to get a 600 VA unit.
 
Last edited:
I use a microtek twin guard pro+ 1000va UPS. Same situation as yours except the generator takes around 20 seconds each time. My PCs peak load is 650W, I have plugged in my internet router and a single monitor. I also have an extension board with 5 pins plugged into it (I don't know if that is safe but haven't had any problems yet) which has a 50w speaker plugged into it. My UPS has just enough power until the gen kicks in. If it takes too long I usually put my computer to sleep.
 
It must've been. Pretty sure this was around for a couple of years even before I bought it. But it's solid, still works and I am yet to change the battery.
 
Not answering your question but more of a heads up, I bought a 2200VA unit and it had terrible fan noise when it was under load. Had a few calls n tech visits from APC to get it replaced, new unit is much more silent.
 
Slayer88 said:
Not answering your question but more of a heads up, I bought a 2200VA unit and it had terrible fan noise when it was under load. Had a few calls n tech visits from APC to get it replaced, new unit is much more silent.
Click to expand...
In the other thread also someone mentioned that many people have needed to get replacement batteries/units from APC before their units worked properly. It's a factor in my decision for sure.

Sidu said:
I don't even know if there is a fan inside my 1000va unit. Maybe for higher volt-amps?
Click to expand...
There would be. You have a transformer in there, and that would need cooling.
 
True. Well I guess you could get a microtek UPS and connect an extension cord to it. (I still don't know if it is safe).
 
Sidu said:
True. Well I guess you could get a microtek UPS and connect an extension cord to it. (I still don't know if it is safe).
Click to expand...

I mean, people say don't do this but I think it's mostly UPS company people wanting to sell more UPSes. I used 2 extension cords chained together with my old APC for years and it was fine.
 
Emperor said:
can you post image of same?
Click to expand...
Sorry that was a long time ago in a different house. I'm not using a UPS at the moment at all.



I reconsidered my load requirements and bought a CyberPower BU600E from MD Computers. https://mdcomputers.in/cyberpower-600va-bu600e-in.html
The major selling point for me for this unit was that I can turn the damn beeping off. None of the <10K units from APC or Microtek offer this.
 
Last edited:
calvin1719 said:
Sorry that was a long time ago in a different house. I'm not using a UPS at the moment at all.



I reconsidered my load requirements and bought a CyberPower BU600E from MD Computers. https://mdcomputers.in/cyberpower-600va-bu600e-in.html
The major selling point for me for this unit was that I can turn the damn beeping off. None of the <10K units from APC or Microtek offer this.
Click to expand...
I doubt a 600VA UPS can handle a gaming PC well, unless it is like i3 + 1650 or something. You mentioned 300W load - did you measure it via a wattmeter or something at plug point? Did you include a monitor?

Don't check HWinfo or similar software for numbers. My GPU (~200W) + CPU (~60W) totals to 260W while gaming but my PC's actual power draw is 350-380W on load + additional 25W for monitor, measured at the plug point where UPS connects. My PC's power draw for non-gaming tasks like web browsing is 180-200W (incl. 25W of monitor).
 
OMEGA44-XT said:
I doubt a 600VA UPS can handle a gaming PC well, unless it is like i3 + 1650 or something. You mentioned 300W load - did you measure it via a wattmeter or something at plug point? Did you include a monitor?

Don't check HWinfo or similar software for numbers. My GPU (~200W) + CPU (~60W) totals to 260W while gaming but my PC's actual power draw is 350-380W on load + additional 25W for monitor, measured at the plug point where UPS connects. My PC's power draw for non-gaming tasks like web browsing is 180-200W (incl. 25W of monitor).
Click to expand...
10105f + 970
I didn't measure at the plug, those numbers are from hwinfo and some approximations.
 
calvin1719 said:
300W for the cpu+gpu is a benchmark load. Even if I'm playing something at the time, it's highly unlikely that it'll be maxing both.
Click to expand...
I underestimated how much my PC consumes as well. My flatmate also has a gaming PC which draws upto 200W on non-gaming usage & 400W on gaming (incl. monitor). Our electricity bill doubled when we both shifted to gaming desktop from laptops.

Your CPU is 65W (it might draw 50W+) like mine & GPU is 150W (vs 200W for me). So you are cutting close, but will likely work. You are underestimating power draw of other components like I did. Anyways, you didn't order from, so no turning back anyways.

See what happens.
 
Back
Top