GPU - MX RX580 Armor OC ( Out of warranty)
PSU - Cooler master V750
Others - Z170 Sabertooth + 6700K + GSKILL 2x16B @ 3000
Couple of months ago, my system crashed once with Asus surge protection message. That time I cleaned up the grill, fan, gpu etc and it ran fine thereafter.
Yesterday I faced following issues.
Observation 1
- While playing Far Cry 4 ( set at 2560x1080 @ Ultra ) > screen turned blank > after few sec POST beep > Asus surge protection triggered
- So I cleaned again, and it ran fine for few hours
Observation 2
- After couple of hours post cleaning, system crashed ( turn blank screen > few sec > restart ) every-time
--- Game would start.
--- Upon Windows load > login screen > press enter to focus pin window. However this behavior was not consistent
--- On running fur mark
=== I removed the gpu, and ran igfx ... all well
=== Removed AMD drivers (safe mode) , and reinstalled
Observation 3
- Post drivers reinstall, I ran Furmark at lowest res ( 400x300 .. i guess ). The window showed up for a sec and then the crash cycle triggered.
- I ran CPU benchmarks to generate load on PSU , it ran fine.
- Don't have a second system to test
Any suggestions what could be the issue? Is the GPU dead?
PSU - Cooler master V750
Others - Z170 Sabertooth + 6700K + GSKILL 2x16B @ 3000
Couple of months ago, my system crashed once with Asus surge protection message. That time I cleaned up the grill, fan, gpu etc and it ran fine thereafter.
Yesterday I faced following issues.
Observation 1
- While playing Far Cry 4 ( set at 2560x1080 @ Ultra ) > screen turned blank > after few sec POST beep > Asus surge protection triggered
- So I cleaned again, and it ran fine for few hours
Observation 2
- After couple of hours post cleaning, system crashed ( turn blank screen > few sec > restart ) every-time
--- Game would start.
--- Upon Windows load > login screen > press enter to focus pin window. However this behavior was not consistent
--- On running fur mark
=== I removed the gpu, and ran igfx ... all well
=== Removed AMD drivers (safe mode) , and reinstalled
Observation 3
- Post drivers reinstall, I ran Furmark at lowest res ( 400x300 .. i guess ). The window showed up for a sec and then the crash cycle triggered.
- I ran CPU benchmarks to generate load on PSU , it ran fine.
- Don't have a second system to test
Any suggestions what could be the issue? Is the GPU dead?