Any suggestions?_pappu_ said:try shops other than prime man
assemble it yourself by collecting parts from wherever u get them cheap![]()
F|0ccY said:Like I said, Im planning on getting it from newegg.
And yeah, VX 450 for Rs 3250/-, sorry for the typo, this cold isn't helping![]()
Internal I/O
- 1 x Floppy Port supports up to 2.88 MB
- 1 x ATA 133/100/66/3 IDE connector
- 4 x SATA 3Gb/s connector
- 4 x USB header (support 8 ports)
- 1 x FP-Audio
F|0ccY said:Are you sure? Prime ABGB's online store doesn't mention it.
F|0ccY said:Ok, I'm planning on upgrading my rig after almost 3 years.
Udit said:[OT] liar liar August 2006 to August 2008 is 2yrs :tongue: [/OT]
buy:
Intel Q6600 (Q9450 preferred)
MSI P45 Neo
Transcend 4 x 2GB ddr2 800 ram
Corsair VX450
Ati 4850
Aquamatrix said:Yes it does have an IDE connector.
BIKeINSTEIN said:For what- for what pupose do you suggest 4750 CF? :S
F|0ccY said:Hell, it feels like its been 3 years:bleh:
1. VX 450? isn't that cutting in a little too close? especially after Mr.Bikie's post?
2 & 3. For now, I guess ill stick to 4GB.The Q9450 is over my budget, I'd consider it if it weren't 6k more.Even the MSI P45 Neo has just 1 IDE connector, won't that be a problem?And if necessary can I do some OC'ing with that board?And, 4850? are you sure?
4.It has ONE connector, not 3.How am I supposed to manage a hdd and a drive with one slot?
Mere baap- A CM extreme power 600 costs 3k odd, VX450 costs 3K odd.
This topic has been dicussed to death and beyond.
Read this thread thoroughly and you will undertstand why VX450 is enough and CM600 is relatively crap.
HD 3870 on a VIP 400W (27A @ 12V)
(And he who asked powersafe 500W single rail is enough doubts Corsair VX450 is pretty ironic. You have a lot to learn about PSUs- esp rails, power and power distribution. )
Just becoz you are an old member here- for you one last time.
VX450 has almost all the power on its 12v rails + Corsair rates it pretty conservatively + its more than 80% efficient against 65-70% of cheapo psus.
So going by how CM or other cheapo PSUs manufs label their PSU, its easily a 550-600W if you want to rate it that way.
Read that thread in the link above and all other posts in preceeding and following pages as well- please.
And i said VX450 is minimum- knowing it will run a Q66+IP+4GB+4850+2xHDD+2xODD+2-3x120mm fans pretty fine.
Else get a Corsair TX650/HX620 and throw anything at it- similar to CM or other brand 700-850W- 6K+ odd.
If you are really smart, you won't scrimp on the PSU- that's a challenge.
F|0ccY said:Hell, it feels like its been 3 years:bleh:
F|0ccY said:VX 450? isn't that cutting in a little too close? especially after Mr.Bikie's post?
F|0ccY said:For now, I guess ill stick to 4GB.The Q9450 is over my budget, I'd consider it if it weren't 6k more.Even the MSI P45 Neo has just 1 IDE connector, won't that be a problem?And if necessary can I do some OC'ing with that board?And, 4850? are you sure?
F|0ccY said:It has ONE connector, not 3.How am I supposed to manage a hdd and a drive with one slot?
sTALKEr said:3. If you are getting the gfx locally then dont look beyond the 4850 for around 11k all inclusive. if you are looking to get it from newegg then i would also suggest that you consider the 9800gtx+ for around the same cost... 200USD..
4. you can connect 2 devices to 1 IDE port.
Yes, I DO know you can connect 2 devices but, first understand my problem, how am I supposed to use one cable to connect 2 devices. especially a HDD and a Drive, it would have been easier if it were either 2 Drives or 2 HDD's.Udit said:hdd as master & dvdrw as slave on one cable as one cable has two connectors
F|0ccY said:Then what would be ideal for 14x9?Also taking into consideration my case, I don't think the gtx+ would fit.